Author Topic: Chemung street stock gear?  (Read 4290 times)

Wickerman667

  • Newbie
  • *
  • Posts: 97
    • View Profile
Chemung street stock gear?
« on: June 15, 2015, 01:43:16 PM »
Wondering what gear to run if I decide to go try chemung out some weekend? Running a 3 speed Saginaw.


chief57

  • Champion
  • ****
  • Posts: 2251
  • NO Weasels
    • View Profile
Re: Chemung street stock gear?
« Reply #1 on: June 16, 2015, 05:56:44 AM »
unless you are running it in third it would be nice to know what ratio you have in that tranny's second gear. any grooves on the input shaft of the trans.? this info. will change your answer.
You can't buy intelligence, but I can give it away.

GOODGUYSRBACK

  • Rookie
  • **
  • Posts: 244
    • View Profile
Re: Chemung street stock gear?
« Reply #2 on: June 16, 2015, 08:59:32 AM »
With the nyss tour we ran 600 final drive turned 6500 could have used 633 if your motor could handle it.  You need the gear off the corner


Joe11

  • Rookie
  • **
  • Posts: 498
    • View Profile
Re: Chemung street stock gear?
« Reply #3 on: June 16, 2015, 09:22:06 AM »
I agree, final drive in the 6.20 - 6.33    Some guys with 6.50 but our motors are not that stout!!
"It's better to be a 'has-been' than a 'never-was'.....  not that I am EITHER!!


Wickerman667

  • Newbie
  • *
  • Posts: 97
    • View Profile
Re: Chemung street stock gear?
« Reply #4 on: June 16, 2015, 09:45:18 AM »
Sadly I don't know anything about the tranny since we bought the car race ready and I'm not a Chevy guy, I'll have to check.

Wickerman667

  • Newbie
  • *
  • Posts: 97
    • View Profile
Re: Chemung street stock gear?
« Reply #5 on: June 21, 2015, 10:47:03 PM »
No grooves on the input shaft, I only know that cause the engine is out right now, lol, other problems.