Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - camero02

Pages: [1]
1
The Tech Barn / Rear end
« on: December 06, 2016, 05:59:58 AM »
I have a 72 chevelle chassis with a 8.5 rear end. It is damaged. I want to put a 7.5 rear end in the car. Is this possible?

2
The Tech Barn / skipping.
« on: September 01, 2016, 11:17:43 AM »
My car has a skip and I can not seem to figure it out. Changed plugs cap rotor check all the wiring. Timing is right. Changed battery. ??????? Have no idea.

3
Racing Discussion / Engine Builder
« on: June 06, 2016, 06:44:20 PM »
Looking for a good Engine Builder Near Rochester or Syracuse . Need a Street Stock motor build.

4
The Tech Barn / Engine Builder
« on: June 06, 2016, 06:36:30 PM »
Looking for a good engine builder near Rochester or Syracuse. Need a Good Street Stock motor build.

5
The Tech Barn / Car cutting out
« on: June 22, 2015, 09:27:53 AM »
I race at canandaguia and I am having a problem with the motor dying out half way down the back straight.  The front straight is fine. it seems like the cam gives up at 6500 the car does bot go over 6500 rpm. 1.76 power glide and 342 rear gears. the motor is a chevy 355.

6
The Tech Barn / Power glide Tranny
« on: September 26, 2013, 05:18:16 PM »
How much of an rpm difference would it be running a 182 power glide rather than the 176. I have 342 gears in rear end

7
Racing Discussion / Burnell Race Party.
« on: February 25, 2012, 10:26:03 AM »
Frank "Bubba" Burnell race party tonight at North seneca sportsmans club rt 318 waterloo ny. ziti dinner keg of beer and a whole lot of raffles. Last year one winner took home $700 from the 50/50. Party starts at 5. Come out and support Bubba. for more info contact bubba at 315-856-0969

8
The Tech Barn / motor knock
« on: November 04, 2011, 07:13:48 PM »
Had a motor knock last time i raced now i went out to start the car knock gone wtf... it sounded like it was upper end. great oil preasure. not sure what it was.

9
Racing Discussion / Thunder mountain
« on: September 20, 2011, 06:56:17 PM »
Looking for rules for thunder moutain pure stocks. I want to go there this weekend but not sure of the rules.

10
The Tech Barn / Thunder Moutain
« on: September 20, 2011, 06:42:02 PM »
Anyone know the purestock rules for thunder moutain? Carb,Headers ect

11
The Tech Barn / Tranny
« on: May 04, 2011, 11:56:24 AM »
I have a turbo 350 with 373 gears in my car and i run a half mile track. The car only turns 5300 to 5500 rpm in second gear. Can the timing being off cause this problem? I should be turning around 5800 to 6000

12
The Tech Barn / Checking front end
« on: April 02, 2011, 08:38:16 AM »
Its been a few years since i raced. How do i check the tow in on a metric pure stock chassis?

13
The Tech Barn / Turbo 350 or 1.82 power glide
« on: January 30, 2011, 12:06:52 PM »
Just a quick question. I have 373 gears in the rear end of my car, if i run a turbo 350 the rpm range is 5800 to 6000 i was just wondering if i run the power glide where would that put my range on a half mile track? canidaiqua (sp).

Pages: [1]